Check out these clips...
Moderators: pompeiisneaks, Colossal
- Funkalicousgroove
- Posts: 2235
- Joined: Mon Jul 25, 2005 8:04 pm
- Location: Denver, CO
- Contact:
Re: Check out these clips...
That amp is the 70's style circuit, 100K slope, 100K/1k5 plate/cathodes, Funky OD entrance network.
Lance isn't using a loop , but he is plugged into the FET input.
5uf bypass caps all around, 100W amp w/1/2 power switch. JJ Pre's Tung-sol 6l6's
Brandon
Lance isn't using a loop , but he is plugged into the FET input.
5uf bypass caps all around, 100W amp w/1/2 power switch. JJ Pre's Tung-sol 6l6's
Brandon
Owner/Solder Jockey Bludotone Amp Works
Re: Check out these clips...
What is that? Havent heard that term before. Is that a dumble term?Funky OD entrance network
I love my rail tone amp!
- Funkalicousgroove
- Posts: 2235
- Joined: Mon Jul 25, 2005 8:04 pm
- Location: Denver, CO
- Contact:
Re: Check out these clips...
220K/500pf to ground, 1.2M in series, 33k to ground
You do not have the required permissions to view the files attached to this post.
Owner/Solder Jockey Bludotone Amp Works
Re: Check out these clips...
What's the PT bias tap voltage on the 1977?
-ER
-ER
- UltraHookedOnPhonix
- Posts: 414
- Joined: Thu Dec 15, 2005 9:32 pm
- Location: Dumbleland
Re: Check out these clips...
Looks like the Pre-OD network showed up in the Kitty Hawk clone as well...
You do not have the required permissions to view the files attached to this post.
- Funkalicousgroove
- Posts: 2235
- Joined: Mon Jul 25, 2005 8:04 pm
- Location: Denver, CO
- Contact:
Re: Check out these clips...
Twin Iron 330-0-60-330ER wrote:What's the PT bias tap voltage on the 1977?
-ER
Owner/Solder Jockey Bludotone Amp Works
Re: Check out these clips...
"but he is plugged into the FET input"
Were there any ODS made that had one input and had the fet switchable by a footswitch like the SSS?
Were there any ODS made that had one input and had the fet switchable by a footswitch like the SSS?
- Funkalicousgroove
- Posts: 2235
- Joined: Mon Jul 25, 2005 8:04 pm
- Location: Denver, CO
- Contact:
-
stratcat62
- Posts: 95
- Joined: Sun Jun 04, 2006 11:28 pm
- Location: Northern VA
Re: Check out these clips...
If you run out from the speaker jack on the small amp to a dummy load that has a line out with volume adjustment (ex. Hot Plate), then you don't need a speaker. Kimock runs his DeArmond combo speaker and all and has a cable running from the +/- connectors out to his speaker to line level attenuator. I've run amps through the Hot Plate into the input of my Twin with the line level way down, which pretty much turns the Twin into a power section for the little amp.ER wrote:One guy mentioned that it was close to the sound Steve Kimock gets with his dearmond, and the little SE dearmond I built does a pretty job at getting that sound.
Any ideas on how Kimock pads down the output to go to a bigger amp?
-Erik
-
hitchcaster
- Posts: 296
- Joined: Thu Jun 01, 2006 12:30 am
Re: Check out these clips...
UltraHookedOnPhonix wrote:Looks like the Pre-OD network showed up in the Kitty Hawk clone as well...
they didn't get the memo on the heaters though
Re: Check out these clips...
What is that? Havent heard that term before. Is that a dumble term?
Yeah you've heard of the term HRM for Hot Rubber Monkey!!
This is the FMN Funky Monkey Network!!!...LOL!
T
Re: Check out these clips...
Sorry for coming in late here guys but I REALLY love the tone on the clip. Brandon, if you don't mind, what were the pot values? Classic 250K/100K/250K or the older 70's 500K/250K/1M?
<i> "I've suffered for my music. Now it's your turn."</i>
- Funkalicousgroove
- Posts: 2235
- Joined: Mon Jul 25, 2005 8:04 pm
- Location: Denver, CO
- Contact:
Re: Check out these clips...
send a PM, Big Brother is watching
Owner/Solder Jockey Bludotone Amp Works
Re: Check out these clips...
Not if his name is chimeboss! He's been banned, I believe.Funkalicousgroove wrote:send a PM, Big Brother is watching
Wife: How many amps do you need?
Me: Just one more...
Me: Just one more...
Re: Check out these clips...
Maybe the "Big Fella" himself. 
<i> "I've suffered for my music. Now it's your turn."</i>