This is a broad that I purchased on EBay a few years back, Listed as Mystery Boards and recently found out that this was an old board from a Fender 75 that had not been installed into anything. That is gonna be my project here soon. I did not place the Photo Cells on the board below the drawing since this was an old picture and I hadn't found them at that time. I can now purchase the Photo Cell from Antique radio Electronics. The values are from the Board itself, but I have yet to compare this to the schematic. I will post my results after i have. The drawing is marked with the values but you have to enlarge the drawing to see them...Thanks
Last edited by 73GTV on Mon May 27, 2013 2:11 am, edited 1 time in total.
73GTV wrote:Thanks Cinci, I should proof read my post better.
Question: Do you still get up to Dayton to Mendelson Electronic?
Mendelson's is still there, but I haven't been. Looks like it might be worth a visit.
You need to go on a weekday and head for the 4th floor if memory serves me..All the Vintage Amp, and electronic supplies, etc... you can spend hours searching for Capacitor values, resistors, wiring etc.. Use to stay in the area and would make that trip weekly. Then Mendelsons would sponsor thier annual Hamfest around this time of the year.
They are also the parent company of Parts Express, with Pioneer and MCM being a city block or two from their warehouse in Springfield, Oh.
Now back to the original subject of the post. This is the original board in sections. Sorry if its not as clear as I would like, Cell phone camera used.
I'm wondering that as well.
I threw away a 75 board a couple of months ago.
Owner wanted a better amp built into the chassis, he could not stand the drive on it.
(Typical Fender).
Only thing he liked was the cleans (again, typical).
rather than try to mod it I built an entirely different circuit into it.
Hummm!! Not a lot of interest in just posting this layout I gather.
No I'm just posting this layout in case someone out there needed a this board layout...When I purchased these boards, I figured someone else also had made a purchase of these items. I have the component listing but, will post that later, but based on these inquiries, I may be wasting my efforts.