SE amps

[jestaudio]

still toying with the idea of a SE based on either a 6l6 or a el84 but am now thinking about maybe kt66 as well, is there a optimal OT that would suit al opf the above lus i assume there would be some happy meduim on screen voltages that would enable me to use all three valves at will.

[wsaraceni]

wouldnt the 125ESE work ok for what you want?

http://www.hammondmfg.com/125SE.htm

[jestaudio]

wouldnt the 125ESE work ok for what you want?

http://www.hammondmfg.com/125SE.htm

Should do as long as i can keep all the loads correct when switching between tubes, under ideal circumstances i would want to use the same tap irrespective of tube selection but i can't see how i could get it to work

[Zippy]

still toying with the idea of a SE based on either a 6l6 or a el84 but am now thinking about maybe kt66 as well...

You're not alone...


https://tubeamparchive.com/viewtopic.php?t=14349

[jestaudio]

still toying with the idea of a SE based on either a 6l6 or a el84 but am now thinking about maybe kt66 as well...

You're not alone...


https://tubeamparchive.com/viewtopic.php?t=14349

Interesting reading, looks like RJ and co have done all the hard work

[passfan]

http://www.ax84.com/p1x.html

This one can run octals from 6V6 all the way up to a 6550 by adjusting the bias resistor.

[kwijabo]

the transformer i'm using in my SE build you can buy here.

http://shop.dobermanamps.com/category-s/27.htm

From the site:
* Primary winding is rated to 145ma full duty or 180ma for typical audio (15-20 watts)

Wiring:

pri Brown=0
brn/yellow=2.5K
blue/yellow=4K
blue= 6K
sec black=0
yellow=4 ohms
green= 8 ohms
orange=16 ohms