Cab Switcher (Passive)

[selloutrr]

should be good.

Make sure you rough up the surface you are putting epoxy against to help it grip.

if you have any doubt if something is conductive you can always test it for continuity.

[ChrisM]

Mixed it up and threw it on. Resistors seem pretty solid, will test again later though once the epoxy is fully cured, will test then to see if conductive.

The unit is for switching between speakers on a 10W SE amp so I figure the 100R 40W resistor is more than enough.

Thanks for all your help btw!

[selloutrr]

you should be covered. Happy to help.