AO44 questions

[lovecoffee01]

I've acquired a m102 organ with an ao29 and ao44 chassis. I also have a ao43 chassis that I'm planning on doing sluckey's plexi6v6 build with but need to wait for some funding. The ao44 chassis seems like a pretty good candidate for a fairly already complete build that I need few parts to complete. I'm completely new at this but have been lurking for quite a while. I'm thinking of turning it into the sluckey peewee but would like a bit higher gain of an amp than the ab763. I'm thinking of pasting the preamp from a trainwreck express onto the input of the phase inverter and adding a presence control to the cathode of the third cathode. Would the preamp work with existing voltages or would they have to be tweaked? Anything else I need to consider? Would my presence control work? I know for all the pots etc. I'd need to use a different chassis. Thanks in advance.

[Stevem]

If you simply move the feedback tap off of the Pee wee to the 4 ohm tap you will 30% more gain until that global feedback voltage runs out.
That might just be enough for your needs, or you can just open that circuit altogether.

[lovecoffee01]

It doesn't have a 4 ohm tap.

[Stevem]

Ok, then drop that 100k resistor feeding then presence pot down to about 70k and the effect will be the same.

[lovecoffee01]

Okay I'll try playing with values.