Octal Preamp

[C Moore]

Anybody have a schematic for an amp that uses a:
5Y3
1 eight pin preamp
1 8 pin phase inverter
2 x 6V6
Thank You

[cbass]

Something like this?
http://www.webphix.com/schematic%20heav ... _schem.pdf

[rdjones]

The first one that comes to mind is the 5C3.

[C Moore]

That one I have, but you would not know that because I was too stupid to mention the obvious.
But Thank You.
Guess I am looking for a Non-Fender schem if there is one. I know Red Iron uses Octals in the pre, but I do not know if they have the configuration I need.
Thanks Again

[surfsup]

I'm working on one now with 2x6v6, a 6sn7 pi (yea i think i can get this to work) and some 6sj7s but i'm going for a switchable OD section, as well. I would be interested to look at what you dig up so please share if you dont mind

[rdjones]

How about a Gibson GA-20 minus one of the inputs ?

rd

[M Fowler]

Gretsch Playboy.

[Phil_S]

How about a Gibson GA-20 minus one of the inputs ?
rd

+1 on that, here: http://home.comcast.net/~psymonds/GA20.htm
I love that amp!

[C Moore]

I'm working on one now with 2x6v6, a 6sn7 pi (yea i think i can get this to work) and some 6sj7s but i'm going for a switchable OD section, as well. I would be interested to look at what you dig up so please share if you dont mind

10-4
No Problem.....

[rdjones]

Gretsch Playboy.

Is there a mistake in that drawing ?
Where does the first stage and the second half of the PI get B+ ?

I think there is a jump and a joint mixed up.

rd

[rdjones]

Try this.

[Andy Le Blanc]

I really liked 1/2 6sn7, tone volume, 6sj7, 1/2 6sn7 split load...