Fender Princeton Reverb with celestion g10 gold 10" 40-

[morrisonmagic]

So I just put in a celestion g10 gold 10" 40-watt alnico in my Princeton Reverb reissue and what a great improvement. I think the Jenson 10 was fine but I found it to be overally bright and lacking in overall balance.

That is definitely not the case with the celestion g10 gold 10" 40-watt alnico. Firstly the bright top end was replaced by a clear vibrant top end that I was looking for. The overall tone is just far warmer and more balanced sounding to me. I also noticed that the speaker does not break up until much greater volume. Since I use a tube screamer as my primary overdrive it sounds much cleaner and warm as well over driven.

My verdict is money well spent and has given me one bad ass amplifier.

[Firestorm]

Good advice. In my experience, the speaker for a Princeton Reverb is a C10N. Hard to find sometimes, so the alternative is welcome.

[ampmike]

I allways wanted to change the speaker in my Diaz PXX,but it wont fit in the little combo cab,Everything but the 10 jensens hits the power tubes.Just a
bad design in the combo cab.I might put together a 1x10 cab for one of those.I agree about the money as well,Glad it worked for you,Mike

[pops]

I allways wanted to change the speaker in my Diaz PXX,but it wont fit in the little combo cab,Everything but the 10 jensens hits the power tubes.Just a
bad design in the combo cab.I might put together a 1x10 cab for one of those.I agree about the money as well,Glad it worked for you,Mike

Can you use a 10" anlico without the cover on the magnet, should be smaller and not be in the way.

[morrisonmagic]

The speaker fit in my without any problems.

[ampmike]

I allways wanted to change the speaker in my Diaz PXX,but it wont fit in the little combo cab,Everything but the 10 jensens hits the power tubes.Just a
bad design in the combo cab.I might put together a 1x10 cab for one of those.I agree about the money as well,Glad it worked for you,Mike

Can you use a 10" anlico without the cover on the magnet, should be smaller and not be in the way.

Thanks Pops,Let me check that out.Good idea,Ive allready blown one speaker so i never count on this one.Im gonna look into that,Thanks Buddy