Bias points for my Tremolux

[angelodp]

I have read about a clever method to create bias test points for a fender amp. I have a blackface tremolux that I have taken the ground switch and death cap out of. I installed a three prong safety plug. I capped the port. In this description it mentioned installing 1 ohm resistors on pin 1 of the power tubes an then using a stereo jack for the bias points ..... but it does not elaborate beyond that. Could this work and what would the wiring look like.

ange

[theundeadelvis]

Check out the second kit down. It has a description of what I think you're talking about: https://taweber.powweb.com/store/kits_weber.htm

[FUCHSAUDIO]

E-mail me for a diagram. Replace your AC plug with an octal, and you cna easily have a test point for each tube. Two resistors, and an hour of work.

[jjman]

I did that to my '71 DR.