Tweed 5e3 PLUS! with reverb??

[pdf64]

… there are production amps with similar arrangements that work fine and it takes the reverb entirely out …
SC200HB_pg1.pdf

The reverb output of that Imperial looks to be permanently mixed into the signal path, it’s only the inputs to the reverb driver that get disconnected by the switch.

[ChopSauce]

I don't understand this. I saw one schematic directly switching the input to the reverb tank to ground but I'm not sure how the reverb transformer handles that?

I am also surprised that a subjet as obviously "of wide interest" as "how to put a reverb in a 5E3" still did not get more than finely spreaded information...
(yet I can understand the reasons for that - given that some builders make part of their business out of it)

Also, have you seen: https://el34world.com/Forum/index.php?topic=7957.100

[bepone]

I used a 3M3 to WET/DRY SIGnal
I tryed in two places. RED LINES
After TONE, and Before MASTER

before Master also is possible, how you like that?

[maxkracht]

maxkracht wrote: ↑Tue Sep 07, 2021 10:55 pm
… there are production amps with similar arrangements that work fine and it takes the reverb entirely out …
SC200HB_pg1.pdf

The reverb output of that Imperial looks to be permanently mixed into the signal path, it’s only the inputs to the reverb driver that get disconnected by the switch.

Whoops, my memory of how that worked didn't match reality. I guess I don't understand why you couldn't switch the whole thing out. I'm probably missing something obvious...

[M Fowler]

From Hoffman Amps .sch files 5E3 with Reverb schematic.

Mark

5E3-R.bmp

5E3-R.bmp

[Ranalog]

NICE!!!
it's near I take for the experiment....
If I down the mix resistor I get better resouls.... I amb going to try DWELL POT!

Thnak! in a few minuts I'll have something!