on my way to developing skills to handle the rigors of graph paper, this lined school paper struck me as a convenient intermediary
not positive on the pi filter or the value of plate load resistor on V2b, but this should have addressed most of the concerns presented by the previous draft.
Thanks again for those of you who chimed in, a couple of the items I just forgot and a couple others I was not aware enough to know to include
schematic critique
Moderators: pompeiisneaks, Colossal
-
centervolume
- Posts: 19
- Joined: Mon May 30, 2011 3:41 am
- Location: frankentitz
draft 2
You do not have the required permissions to view the files attached to this post.
a vacuum tube?! is that fire in there??
-
centervolume
- Posts: 19
- Joined: Mon May 30, 2011 3:41 am
- Location: frankentitz
layout view
I am posting this to check for visibility as try to I improve my drafting.
I'm not yet drawing in the PT, rectifier and bias connections because the main board, pots and sockets connections are still in process.
Quick question: the left terminal of the middle pot, that should go to ground right?
I'm not yet drawing in the PT, rectifier and bias connections because the main board, pots and sockets connections are still in process.
Quick question: the left terminal of the middle pot, that should go to ground right?
You do not have the required permissions to view the files attached to this post.
a vacuum tube?! is that fire in there??
It appears so
The way it's drawn in the schematic the left terminal, when looking from the rear of the control, should be grounded.
I ground all the controls on the can, (back side of the pot) with a common lead and then run that to ground. But you need a hot soldering iron and flux for that and a bit of a technique. A good connection to the chassis with a star washer on the controls also works well.
silverfox.
I ground all the controls on the can, (back side of the pot) with a common lead and then run that to ground. But you need a hot soldering iron and flux for that and a bit of a technique. A good connection to the chassis with a star washer on the controls also works well.
silverfox.