locating parts for Express

[Richie]

I'm going through some stuff, still counting out some things.
I have some of the original clips if you or anyone is interested in those.

I may have some perf board that you can make or get 2 power supply boards from the one sheet. Its not long enough for the preamp board.

And the board is still sealed in the plastic. I think the power boards take like 23 clips. I just pushed the clip in for the pic,its not inserted all the way or been seated or tabs bent on bottom. The clips are getting very hard to find.

[Blackburn]

Is that board the same material in some TWs? Nice stuff!

[Richie]

The early ones used this type board. the later ones went to the white or cream and different spacing. Here[below] is a pic of BOM in franchesca. I'm pretty sure that is the old Keystone part number on the package. But probably like many things, it could have been sold by others like Calelectro, G-C. Olson and many other electronic parts places.

[Blackburn]

The early ones used this type board. the later ones went to the white or cream and different spacing. Here[below] is a pic of BOM in franchesca. I'm pretty sure that is the old Keystone part number on the package. But probably like many things, it could have been sold by others like Calelectro, G-C. Olson and many other electronic parts places.

Good to know!

[Richie]

getting a debug mode when trying to reply so bare with me on the replies.


I know most call these flea clips,so i'm posting a couple pics, this is showing a flea clip, on the left which is smaller, then the 3 fork terminal used in the wreck amps in the middle, then another type on the right. So if anyone wanted to know what a true flea clip looked like. Those are made for the smaller perf board.