z wreck build power supply issue

[Mainetone]

Just completed a a zwreck build, having current draw issues. I used a two el84 output stage, gz34 rectifier. Power tranny is a from a hammond ao43 this is the fourth wreck style build I have completed using this setup all the others work flawlessly. Power supply is as follows

from rectifier to stby, stby to 250ohm resistor and 40mfd cap and bplus 1
output side of resistor supplying bplus 2 then dropping string paralleled to b plus 3,4,5. of bplus 2 node

I have low bplus 1 only 100v. The amp sounds wicked good, less this little current draw issue, any thoughts

[ampgeek]

Funky PT or rectifier perhaps?

What are you seeing for voltages on the PT primary and at all the used pins of the GZ34?

Dave O.