Rocket Power supply
Moderators: pompeiisneaks, Colossal
-
Funkalicousgroove
- Posts: 2235
- Joined: Mon Jul 25, 2005 8:04 pm
- Location: Denver, CO
- Contact:
Rocket Power supply
Last edited by Funkalicousgroove on Sat Jul 12, 2008 2:59 pm, edited 1 time in total.
Owner/Solder Jockey Bludotone Amp Works
-
Funkalicousgroove
- Posts: 2235
- Joined: Mon Jul 25, 2005 8:04 pm
- Location: Denver, CO
- Contact:
AC30 it is
Last edited by Funkalicousgroove on Sat Jul 12, 2008 2:59 pm, edited 1 time in total.
Owner/Solder Jockey Bludotone Amp Works
Re: Rocket Power supply
Have a look in the files section there should be two circuits there. One has the typical Trainwreck power supply but the 1K 25 watt resistor is replaced by a choke. This is the same supply that I saw in a 50 watt Plexi circuit that Trace of Voodoo amps drew up.
Also go through the various posts as Chris G also made a post about power supply values. There is also a picture of a Rocket that was built, nice job too.
Hope this helps.
Also go through the various posts as Chris G also made a post about power supply values. There is also a picture of a Rocket that was built, nice job too.
Hope this helps.
Yours Sincerely
Mark Abbott
Mark Abbott
-
Funkalicousgroove
- Posts: 2235
- Joined: Mon Jul 25, 2005 8:04 pm
- Location: Denver, CO
- Contact:
Re: Rocket Power supply
Last edited by Funkalicousgroove on Sat Jul 12, 2008 3:00 pm, edited 1 time in total.
Owner/Solder Jockey Bludotone Amp Works
Re: Rocket Power supply
Dear Funkalicousgroove
The power supplies are indentical (to my limited knowledge) with the exception of the 1K ohm 25 watt resistor, this is replaced with a choke.
You might also consider using the Komet power supply for this amp, it would work.
The power supplies are indentical (to my limited knowledge) with the exception of the 1K ohm 25 watt resistor, this is replaced with a choke.
You might also consider using the Komet power supply for this amp, it would work.
Yours Sincerely
Mark Abbott
Mark Abbott